Our welfare station was developed for both internal and external use
on a variety of sites, thus providing employees with one location for all
Health & Safety products.
Lightweight (approx 25kgs)
Adapted to customer needs
H 1.725m W1.0m D 1.0m
Re-instatement Depth Gauge
The depth gauge is a simple and efficient product, manufactured from
polyethylene plastic, which has predetermined engraved depths for
carriageways and footpaths. As each classification of carriageway has
a predetermined depth of blacktop, the depth gauge incorporates these
measurements in a stepped system that allows the operative to measure
against backfill to ensure reinstatement is correct. Operatives can also
use the gauge to ensure that street furniture such as road plates and
trench covers have been placed correctly over open excavations.
This helps to ensure that sites are safe for pedestrian and vehicles.
Recyclable - polyethylene plastic can be placed with plastic waste for
Reduction in defects - correct reinstatement depths for footpaths
Durable - can be used in all weather conditions with no degradation.
Compliant - meets required standards for SROH.
Reduces waste - limits the use of excessive materials.
Multi utility use - all utilities involved in reinstatement can use this
Road Plate Mushroom Cap
“The road plate mushroom provides a range of benefits – it improves
security and safety and provides a cost effective, fully recyclable solution.”
Andy Edwards, Innovation Project Engineer, BBUS
The road plate cap was developed to improve site safety when road
plates are used to secure open excavations in the carriageway.
• Cost effective. No reworking of the road plate is required.
• Improves safety. Secured correctly, the road plate mushroom will
• Reusable. Both mushrooms and bolts have been designed for reuse.
• Recyclable. If the mushroom is damaged it can be placed in plastic
recycling waste streams.
Effective securing of road plates has been an industry wide issue for a
number of years. Road plates weigh on average 400kg and are designed
for carriageway use only. The road plate mushroom provides a cost
effective, easy to use solution to this problem, manufactured from cast
nylon for strength and durability. Fitting the device is quick and simple.
The engineer can drill through the existing lifting points on the road plate
and fit both the bolt and securing mushroom in one easy application.
Both bolts and mushrooms are reusable so once work is completed all
products can be stored away for reuse.
Black Road Plate Cap For Tarmac Use
Yellow Road Plate Cap For Concrete Use
Temporary Gulley Cover
“In 30 years of working in the utility industry this is the best product I
have seen to eliminate the possibility of contaminating watercourses.”
Tony Webb, Health & Safety Officer, North West Gas Alliance.
The drain cover seal is designed to seal drains when there is potential
for an environmental incident. By sealing the drain off it will allow time
to deal with accidental spillage or the removal of site spoil before it can
enter a water course.
• 100% Environmental
• Can be recycled again
• Simple installation procedure
• Cost effective
• Protection of watercourses
• Reduce potential for prosecution
• High visibility
The Gully Cover Seal has been designed to reduce the potential for
pollution events. It is very easy to install and can be fixed in place in less
than one minute. If there was accidental spillage or a flooding incident
that could cause an environmental incident, or circumstances where spoil
is deposited in close proximity to gullies with a possibility of
contamination to a water course, then the drain cover should be used.
The process of installation is:
1. Place the cover over the gully.
2. Move the locking bar into the closed position.
3. Use a 13mm socket to tighten the bolt until rubber compresses to
form a seal on the carriage way.
The drain is now sealed and safe from the potential ingress of
contaminants into a watercourse.